Troubleshooting Measures for Oil Leakage of Ironworker
In the process of using hydraulic ironworker, some failures may occurs. Analyzing the reasons for failures correctly is the premise and basis for probleming solving. Here are some fault reasons.
On the one hand, the failure of the hydraulic ironworker may be due to the quality of the equipment itself, so the service life will be very short. There are many different kinds of equipment on the market. Some products are of good quality, while others are not so good. Therefore, in the process of purchasing, don’t be greedy for small and cheap products, but choose carefully and buy better quality products. Good equipment, which reduces the occurrence of failures in the process of use.
On the other hand, in the process of using the hydraulic combined punching and shearing machine, the use environment and the specific operation method will have a certain impact on the equipment. Use it in an appropriate environment and use a more suitable operation method, so as to reduce the occurrence of some faults, so as to truly ensure a better effect in the process of use. Different faults have different causes. After careful analysis, future use will be guaranteed.
Generally speaking, the reasons for oil leakage are as follows.
1.Poor quality tube
Generally, oil pipes are used in the multi-functional combined punching and shearing machine system to realize the circulation of oil, and the types are also rich, such as steel pipes, copper pipes, rubber pipes and so on. But the quality must be good. If it is a relatively inferior oil pipe, its bearing capacity is poor and it is easy to be damaged, thereby causing oil leakage. Therefore, it is very important to choose high-quality tubing.
2. Improper installation
When installing the hard pipe, it should be bent according to the specified bending radius, otherwise the pipeline will have different bending internal stress, and leakage will gradually occur under the action of oil pressure. If the bending radius of the hard pipe is too small, the outer pipe wall of the pipe will become thinner, and the inner pipe wall will have wrinkles, which will cause the pipe to generate a large internal stress at the bend, which will greatly weaken the strength. When the hose is installed, if the bending radius does not meet the requirements or the hose is twisted, etc., the hose will be damaged and oil will leak.
3. Pipe connector
Oil leaking often occurs around the pipe connector. Because the joints are poorly sealed, the sealing oil pressure is much lower than the peak pressure of the hydraulic oil. The fault personnel only need to remove it, wash it, and then tighten it.
CATEGORY AND TAGS:
