Top 10 correct ways to open Ironworker Machine

Before starting the Ironworker Machine, check whether the transmission components and the connecting screws and pins of each part are loose, and whether the electrical grounding is intact.
Before work, lubricate all parts of the Ironworker Machine. After driving for two to three minutes, you can start work without any problems.
Overload is not allowed, and punching and shearing of quenched steel is strictly prohibited.
Wear gloves and labor protection equipment when operating the Ironworker Machine. Sandals and slippers are strictly prohibited.
When ironworker machine punches and cuts, always refuel the punches to prevent the upper and lower punches from skewing.
Pay attention to the safety of your fingers when feeding the Ironworker Machine, especially when the sheet material is not pressed by the presser foot to the end, punching is prohibited.
It is strictly forbidden to disassemble, proofread the cutting blade and punching die when starting up. Don’t hit punches, shears and other parts with force.
Strictly control the specification range of the sheet material, and it is strictly forbidden to punch and cut when it exceeds it.
No other items and a large amount of punching materials are allowed to accumulate in the workplace, and the vehicle must be stopped during adjustment and cleaning.
After the work is completed, the Ironworker Machine must be shut down and powered off in time to clean up the site.

Through the above introduction, I believe that everyone has a better understanding of the top 10 correct opening methods for Ironworker Machine. For more inquiries about Ironworker Machine, please visit our website for review or call for consultation.

CATEGORY AND TAGS: