Hydraulic Ironworker Machine-Daily maintenance
What is the specific daily maintenance method of the Hydraulic Ironworker Machine?
1. Operation method
1. Check the specific conditions of the power supply, observe whether the voltage is stable, and check whether the leakage protector and air switch are intact.
2. Open the wiring cabinet of Ironworker Machine connect it to the wire, and then close the cabinet door.
3. Power on and test the machine, if there is no problem. Observe whether the emergency stop switch is turned on.
4. Connect the foot pedal switch
5. Turn off the power every time the mold is changed
6. After the work is over, the power supply should be turned off, the power supply should be removed, and the site should be cleaned up.
2. Maintenance method
1. Before starting the machine, it is necessary to observe whether the leveling of each part of the machine is intact and whether the electrical contact is intact.
2. Before working, observe whether the Ironworker machine is lubricated, and start the machine and run it empty. If there is no bad phenomenon, then work can be carried out.
3. Do not overload, and it is strictly forbidden to rebuild quenched steel.
4. The staff should wear protective gear and gloves, and it is strictly forbidden to pass sandals and slippers.
5. It is necessary to fill up the Ironworker machine regularly, and it is strictly forbidden to tilt the punching tool.
6. At work, you should pay attention to the protection of your fingers. When the sheet material cannot be pressed to the end, punching is prohibited.
7. During the disassembly of the machine, it is forbidden to strike a part with force.
8. It is strictly forbidden to pile a large amount of other objects in the work area, and you must stop when cleaning.
9. After the work is over, the machine should be shut down, cut off the power supply, and the site should be cleaned up.
10. Strictly control the specifications of punching and shearing sheets, and punching and shearing are prohibited when the range is exceeded.
CATEGORY AND TAGS:
